Engineering Notice Concerning Aileron Pulley Selection

Source: 2000 Beartracks, Bob Barrows

Reference Drawing # 14 - The aileron cable pulley can be changed from a AN210-4A to the 1/2" smaller O.D. MS20220-2 if needed to allow the aileron cable to better line up with the wing strut.

If you use the MS20220-2 pulley you will need to bush its I.D. to 1/4" or use a 5/16" bolt and drill out the pulley bracket.

Inspect the line up of the aileron cable to the pulley, if not close to centered the bracket may need to be adjusted a little for proper line up.

You are not yet authorized to view this page. Learn more here.

0 votes, average: 0.00 out of 50 votes, average: 0.00 out of 50 votes, average: 0.00 out of 50 votes, average: 0.00 out of 50 votes, average: 0.00 out of 5 (0 votes, average: 0.00 out of 5)
You need to be a registered member to rate this post.
Loading...