1998 Tailplane Incidence Adjustment Engineering Change (326 and Below)

Refer to drawing # 19.

Change the 3 7/8" dimension to 3 1/2" as shown in the drawing.

This change will allow for more horizontal stabilizer adjustment range to accommodate various engine installations.

You are not yet authorized to view this page. Learn more here.

0 votes, average: 0.00 out of 50 votes, average: 0.00 out of 50 votes, average: 0.00 out of 50 votes, average: 0.00 out of 50 votes, average: 0.00 out of 5 (0 votes, average: 0.00 out of 5)
You need to be a registered member to rate this post.
Loading...