2005 Annual Fly-In at Barrows Field

This article is available for purchasers of 2005 Beartracks access. Click here to purchase access or validate your prior 2005 subscription. Multi-year bundles are available here.

Gear Geometry and Rod Ends. A safety of flight issue

Source: 2005 Q3 Beartracks
In the service bulletin concerning the replacement of the rod end bearings it was mentioned that the landing gear geometry must be such at the tread is 72” (measured center of wheel to center of wheel) when at normal weight and maximum 74” at gross. These dimensions are critical because the loads on landing gear components increase dramatically as the wheels are allowed to splay out. They absolutely must be held.
To check the spread, you can load the airplane then roll it forward and back, giving the gear time to equalize. Another method is to take two pieces of old Formica counter top, place them face-to-face with grease between them. Then this homemade “slip plate” is put under one wheel and the airplane rocked by the wing tip a few times until everything settles out.
DO NOT UNDERESTIMATE THE IMPORTANCE OF KEEPING THE GEAR TREAD WITHIN THESE LIMITS. ALSO REMEMBER THAT THE ONLY ACCEPTABLE ROD END BEARING FOR THE SHOCK STRUT IS THE AURORA XAM-7M. This magnafluxed bearing can be purchased from AviPro.

This article is available for purchasers of 2005 Beartracks access. Click here to purchase access or validate your prior 2005 subscription. Multi-year bundles are available here.

Cooling: A Black Art

Source: 2005 Q3 Beartracks
Cooling an airplane engine is one of those controversial subjects for which there are few pat answers. What works for one, may not work for the next, seemingly identical, airplane. There are some base line parameters that have to be met and then things are changed from there.

This article is available for purchasers of 2005 Beartracks access. Click here to purchase access or validate your prior 2005 subscription. Multi-year bundles are available here.

Controlling Adverse Yaw: Reflexing the Ailerons

Source: 2005 Q3 Beartracks
As more Bearhawks get into the air we should all be prepared for widely varying comments on the way the airplane handles. Some will love it, and some will dislike it. The difference can most likely be found in how the ailerons are rigged.

This article is available for purchasers of 2005 Beartracks access. Click here to purchase access or validate your prior 2005 subscription. Multi-year bundles are available here.

Aux Tank Installation In Your Bearhawk

Source: 2005 Q3 Beartracks, Mark Goldberg
In the October 1996 issue of the Beartracks, Bob Barrows gives builders his design for an 11-gallon auxiliary fuel tank that fits in the third bay from the wingtip of each wing. Bob didn’t exactly encourage installation of these aux tanks.

This article is available for purchasers of 2005 Beartracks access. Click here to purchase access or validate your prior 2005 subscription. Multi-year bundles are available here.

Continental O-470 Engine Mounts

Source: 2005 Q2 Beartracks, Mark Goldberg
In early March, Justin Brown and I went to Monterrey Mexico to observe the trial fit of the Continental O-470 engine mount designed for the Bearhawk Quick Build kit.

This article is available for purchasers of 2005 Beartracks access. Click here to purchase access or validate your prior 2005 subscription. Multi-year bundles are available here.